CMS Made Simple Forums

I recently designed this for a St. Paul-based spirituality center. http://wisdomwayscenter.org/

Used 1.81
Formbuilder 0.6.3

Don't have all the validation kinks worked out yet, but at least it's working for them...

-- TWWitt

I often wonder why people will post half finished sites in here, I would think they would want to "Show Off" their best work not half baked sites with menu links that don't work, some kind of problem with the page width, etc...

Dr.CSS wrote: I often wonder why people will post half finished sites in here, I would think they would want to "Show Off" their best work not half baked sites with menu links that don't work, some kind of problem with the page width, etc...

Can you  be more specific? I wasn't aware of menu links not working or problems with page width. If there are major problems, I'll certainly remove this post...Sorry to offend. I imagine there may be some minor problems, but I didn't consider the site half-baked, but maybe I'm just clueless?

Sorry it wasn't pointing mainly at you but...

I have 17" monitor and at full width it has a scroll bar at the bottom, meaning it is set to more than 1280 width...

Labyrinth resources to rent goes to 404...

http://wisdomwayscenter.org/other/resou ... s-old.html

And...

http://validator.w3.org/check?verbose=1 ... ter.org%2F

Dr.CSS wrote: Sorry it wasn't pointing mainly at you but...

I have 17" monitor and at full width it has a scroll bar at the bottom, meaning it is set to more than 1280 width...

Labyrinth resources to rent goes to 404...

http://wisdomwayscenter.org/other/resou ... s-old.html

And...

http://validator.w3.org/check?verbose=1 ... ter.org%2F

Thanks for clarifying. I'm working on the validating -- probably shouldn't have posted until I had that worked out.

But the page is only 900px wide. I'm a little surprised you'd have to scroll horizontally.

I see it to FYI... here is why.. http://screencast.com/t/XBDnr5JhLDi  hth cheers -Jeremy

Thanks for that heads up. I had no idea that div was hanging out there. Hopefully have it fixed...