Page 1 of 1
Installation Step 1 Problem (1.4) [solvedish]
Posted: Sat Aug 09, 2008 7:06 am
by trentfred
I am new to CMS Made Simple so I'm sorry if the answer is obvious. I have searched the forum for an answer and have not found anything that helps this exact situation.
I'm trying to install CMS Made Simple 1.4. My webhost is Byethost.com. The Apache version is 2.2.8. Operating system is linux. PHP ver. 5.2.6. MySQL ver. 5.0.51. I used FileZilla to upload everything.
Alright, I have uploaded everything and set all the permissions, added the config file and everything else up to the installation steps on the site. I went to the index.php and it asked what language I wanted and I clicked submit. It then goes to the installation step one page. The page loads with the boxes with the 123456 and the 1 is different color, but it does not have a table that checks everything to make sure I have all the permissions correct and everything. There is also no continue button.
So that means I can't get past the step 1 screen and can't install it. I really hope I can get a fix for this because I really liked this CMS in the demo that I tried.
Thanks for any help
Here's an Image that may help.

Re: Installation Step 1 Problem (1.4)
Posted: Sat Aug 09, 2008 7:22 am
by Dr.CSS
In filezilla I would open the site in the right and open the cmsmadesimple folder on the left and go thru and make sure they both have all the same folders/files every where...
You haven't tried to use .htaccess or anything yet have you?...
Re: Installation Step 1 Problem (1.4)
Posted: Sat Aug 09, 2008 7:26 am
by trentfred
mark wrote:
In filezilla I would open the site in the right and open the cmsmadesimple folder on the left and go thru and make sure they both have all the same folders/files every where...
You haven't tried to use .htaccess or anything yet have you?...
I havent done anything with .htaccess yet. I wasn't sure what to do with that. I didn't know if I needed to make my own .htaccess or which one to use.
so far from looking through there isn't differences, I'll keep looking though
Re: Installation Step 1 Problem (1.4)
Posted: Sat Aug 09, 2008 7:31 am
by trentfred
just now in the install folder the install.css filesize is slightly smaller than the local one.
Re: Installation Step 1 Problem (1.4)
Posted: Sat Aug 09, 2008 8:11 am
by alby
trentfred wrote:
Alright, I have uploaded everything and set all the permissions, added the config file and everything else up to the installation steps on the site. I went to the index.php and it asked what language I wanted and I clicked submit. It then goes to the installation step one page. The page loads with the boxes with the 123456 and the 1 is different color, but it does not have a table that checks everything to make sure I have all the permissions correct and everything. There is also no continue button.
So that means I can't get past the step 1 screen and can't install it. I really hope I can get a fix for this because I really liked this CMS in the demo that I tried.
Probably you have a memory problem.
Call installer with:
install/index.php?debug=1
Alby
Re: Installation Step 1 Problem (1.4)
Posted: Sat Aug 09, 2008 9:26 am
by trentfred
alby wrote:
trentfred wrote:
Alright, I have uploaded everything and set all the permissions, added the config file and everything else up to the installation steps on the site. I went to the index.php and it asked what language I wanted and I clicked submit. It then goes to the installation step one page. The page loads with the boxes with the 123456 and the 1 is different color, but it does not have a table that checks everything to make sure I have all the permissions correct and everything. There is also no continue button.
So that means I can't get past the step 1 screen and can't install it. I really hope I can get a fix for this because I really liked this CMS in the demo that I tried.
Probably you have a memory problem.
Call installer with:
install/index.php?debug=1
Alby
alright I tried that and this time the same page loaded except it now had about 200 of this warning message:
Warning: feof(): supplied argument is not a valid stream resource in /home/vol1/byethost11.com/b11_2073171/fredesign.isgreat.org/htdocs/lib/test.functions.php on line 764
Also firefox blocked a continually rising number of popups.
Re: Installation Step 1 Problem (1.4)
Posted: Sat Aug 09, 2008 2:24 pm
by trentfred
Just now when I tried it, it said "No suitable nodes are available to serve your request."
Re: Installation Step 1 Problem (1.4)
Posted: Sat Aug 09, 2008 3:15 pm
by alby
trentfred wrote:
Just now when I tried it, it said "No suitable nodes are available to serve your request."
Try to upload again whole pack or better download 1.4.1
Alby
Re: Installation Step 1 Problem (1.4)
Posted: Sat Aug 09, 2008 4:47 pm
by trentfred
Ok i've uploaded again and i may have found a possible problem i had. when i'm chmodding do i need to do anything to all the files in the folders i'm chmodding? or anything like that.
Re: Installation Step 1 Problem (1.4)
Posted: Sat Aug 09, 2008 5:34 pm
by trentfred
I did it all again and this time i only get the "No suitable nodes are available to serve your request" message
Re: Installation Step 1 Problem (1.4)
Posted: Sat Aug 09, 2008 9:18 pm
by alby
trentfred wrote:
I did it all again and this time i only get the "No suitable nodes are available to serve your request" message
This is an error at the system level and not with CMSMS.
You should contact your hosting provider and notify them of this issue.
Alby
Re: Installation Step 1 Problem (1.4)
Posted: Sat Aug 09, 2008 11:17 pm
by trentfred
Alright thanks for the help!
Re: Installation Step 1 Problem (1.4) [solvedish]
Posted: Sun Aug 10, 2008 12:03 am
by eddie67
Actualy I had the same problem with one site on a shared hosting.
After searching the forums I found somewhere mentioned that 1.4 is doing more tests during installation, maybe something to do with safe_mode. Also I could not remove folders - maybe something to do with permissions.
Anyway, my solution was to install 1.3.1 back again.. No problem.
Eddie.
Re: Installation Step 1 Problem (1.4) [solvedish]
Posted: Sun Aug 10, 2008 12:10 am
by trentfred
ooooh thanks a lot. I was thinking about trying that, but now i'm definitely going to try it.
lets see if this works.
Re: Installation Step 1 Problem (1.4) [solved]
Posted: Sun Aug 10, 2008 2:32 am
by trentfred
IT WORKS! Its now working! woo!!!!! Thanks to everyone who helped.