Ver 1.1 apply button problem

[DA]

Hi all,

Have updated from 1.0.8 to 1.1

In the page data entry, etc, clicking on apply, it grays out, but that is all, no other reaction. It is as though the 'Link' to what ever it is supposed to do is not working. The submit button does what it is supposed to do.

Editor used is TinyMCE, if this has any bearing. Also, going back to 1.0.8, all works fine.

Any help would be greatly appreciated.

Best Regards
D.A

[moorezilla]

Yeah... the apply button seems to be temperamental. It does not seem to always commit changes. I'm having difficulty reproducing the error, but I DID notice this behavior. I will try to duplicate it tomorrow.

[reneh]

Its confirmed. We work on it....
Thanks!

[reneh]

I have managed to duplicate this problem then using EditArea as editor.
Are you both using EditArea as editor?

[DA]

Hi reneh,

I am using the default TinyMCE 2.2 that is default in CMSMS v1.1.

Thank you for your help.

Best Regards
D.A

[reneh]

For they taht used EditARea we have fixed the EditArea module so this ok now. But haven't reproduced with Tiny yet...

[tsw]

and what browser?

[DA]

Hi tsw,

I only use FireFox for editing. Sorry for not telling you before. I also
tried it in Opera, with the same results, I never us IE.

As I said to you before, I only did an upgrade from 1.0.8 to 1.1.

Also before upgrading I had to uninstall Tiny, and remove it, because
it had httpd owner/permissions.

I did put it back to 1.0.8 and it worked fine, using Tiny 1.0.4.

I also tried the FCK editor, same thing there as well.

I hope this helps.

Best Regards
D.A

[DA]

Further update to my last post.

I did some more experimenting. To cut a long story short.

All via FTP:
1 - Took Tiny 1.0.4 off (was working fine)
2 - Put Tiny 1.0.5 on (worked fine)
3 - Took 1.0.5 off
4 - Put 2.2 back on, now all works.

Now I am thinking, also with my very limited knowledge on this, that my up-grade install had a problem. But the upgrade went fine with no errors reported at the time of up-grade, and the only problem was the apply button. But now all is working fine.

So I am thinking that maybe it was user fault after all, in what ever way. If so I humbly apologize for any inconvenience caused.

Best Regards
D.A